DIN Standards Committee Aerospace
Aerospace series - Wire and cable marking process, UV Laser
Abstract
This document is applicable to the marking of aerospace vehicle electrical wires and cables using ultraviolet (UV) lasers. This document specifies the process requirements for the implementation of UV laser marking of aerospace electrical wires and cables and fibre optic cables to achieve an acceptable quality mark using equipment designed for UV laser wire marking of identification codes on aircraft wire and cable subject to EN 3475 100, Aerospace series - Cables, electrical, aircraft use - Test methods - Part 100: General. Wiring specified as UV laser markable, and which has been marked in accordance with this document, will conform to the requirements of EN 3838. This document is applicable to the marking of airframe electrical wires and cables using ultraviolet (UV) lasers. The laser process practices defined in this document are mandatory.
Begin
2024-12-17
WI
04004948
Planned document number
prEN 4650
Responsible national committee
NA 131-04-02 AA - Electrical cables
Responsible european committee
ASD-STAN/D 2/WG 2 - Cables & Stripping Tools
draft standard
Aerospace series - Wire and cable marking process, UV Laser
2025-07
Order from DIN Media
previous edition(s)
Aerospace series - Wire and cable marking process, UV Laser
2023-03
