2. Getting involved
3. Standards Committees
4. NAGas

DIN Standards Committee Gas Technology

Abstract

This document specifies functional requirements for the design, construction, testing, commissioning/decommissioning, operation, maintenance and, where appropriate, calibration, together with suitable documented provisions for all new gas measuring systems and any major changes of existing systems. This document also specifies accuracy classes of measuring systems and thresholds applicable to these classes. Demonstration of compliance is achieved through the selection, installation and operation of appropriate measurement instruments, together with suitable documented provisions for calculations. Examples of demonstration of compliance are provided for each accuracy class; however, they are not prescriptive solutions. This document is applicable for gases of the 2nd family as classified in EN 437. It is also applicable for treated non-conventional combustible gases complying with EN 437 and for which a detailed technical evaluation of the functional requirements (such as injected biomethane) is performed ensuring there are no other constituents or properties of the gases that can affect the metrological and physical integrity of the measuring systems. This version mentions technical topics to consider when hydrogen and natural gas / hydrogen blends flow through the measuring systems. Blends with a hydrogen content between 20mol% and 98 mol% are not considered by this standard. This standard applies to hydrogen with a purity as specified in CEN/TS 17977 for rededicated natural gas systems. This document can also be used as a guideline for measuring systems for other gases e.g. gaseous CO2 for CCUS. This document does not apply to for raw or sour gases. This document does not apply to for gas measurement in CNG filling stations. This document gives guidelines when designing, installing and operating gas meters with additional functionalities (smart gas meters). Communication protocols and interfaces for gas meters and remote reading of gas meters are outside the scope of this document and are covered by the appropriate parts of EN 13757, which provide a number of protocols for meter communications. Supervisory control and data acquisition protocols (SCADA) are also not covered by this document. Unless otherwise specified all pressures used in this document are gauge pressures. For associated pressure regulating systems the requirements of EN 12186 and/or EN 12279 apply. For requirements on design, housing, lay-out, materials for components, construction, ventilation, venting and overall safety of gas measuring systems within the scope of this document, EN 15001 (all parts), EN 12186, EN 12279 and/or EN 1775 apply additionally, where relevant.

Begin

2023-01-05

WI

00234099

Planned document number

DIN EN 1776

Project number

03201006

Responsible national committee

NA 032-02-05 AA - Gas measuring  

Responsible european committee

CEN/TC 234/WG 5 - Gas measuring  

draft standard

Gas infrastructure - Gas measuring systems - Functional requirements; German and English version prEN 1776:2024
2024-09
Order from DIN Media

previous edition(s)

Gas infrastructure - Gas measuring systems - Functional requirements; German version EN 1776:2015
2016-05